Table of Contents
Advertisement
Section 2 - Chiller System Power, Efficiency, and Thermal Load Input
Status
Navigation:
i-Vu®
Verify network connections are operating. See Device Address Binding (page 45).
1
Input the nominal chiller capacities (tons) required to determine part load conditions.
2
Select whether the power input is actual kW or amperage.
3
Select load input type using temperatures and flow or cooling load input.
4
Enter voltage and power factors from the equipment's specifications.
5
Point Name/Description
The following are statuses displayed from the linked network points. See Device
Address Binding (page 45).
Total Chiller kW — Displays value.
Total Chilled Water Pump kW — Displays value.
If "Amp" network inputs are used for CHWP kW determination, then:
The voltage is ___ volts — Enter value.
The Power Factor is __. — Enter value.
Total Condenser Water Pump kW — Displays value.
If "Amp" network inputs are used for CWP kW determination, then:
The voltage is ___ volts — Enter value.
The Power Factor is __. — Enter value.
Total Cooling Tower Fan kW — Displays value.
If "Amp" network inputs are used for Cooling Tower Fan kW determination, then:
The voltage is ___ volts — Enter value.
The Power Factor is __. — Enter value.
Total Airside Fan kW — Displays value.
If "Amp" network inputs are used for AHU VAV Fan kW determination, then:
The voltage is ___ volts — Enter value.
The Power Factor is __. — Enter value.
Total System kW (Chillers + CHWPs + CWPs + CTs + Fans) — Displays value.
Total Building Cooling Load Tons — Displays value.
Total System kW/ton — Displays value.
Chilled Water System Optimizer v2
Installation and Start-up Guide
Appendix B: The Chilled Water System Optimizer Commissioning view of the Properties page
Properties
Control Program
>
System Power, Efficiency and Thermal Load Input Status
63
General Conditions & Status
>
Range
CARRIER CORPORATION ©2019
Section 2 - Chiller
>
All rights reserved
Advertisement
Table of Contents
