Table of Contents
Advertisement
Fault correction
ID
Message
9014
No Mover1 has been de-
tected! Check if there is a
"Mover1" on the system and
restart the detection.
9015
Too many Mover1's have
been detected! Make sure
that there is only one mover
with Mover 1 magnet plate
set on the System
9016
The Axis "x" gets an enable
command before "Mover1"
has been detected. If there's
no Mover1 on the XTS set
'MoverIdDetectionMode' to
'Standard'
9017
MoverIdDetection was inter-
rupted by changing the
'MoverIdDetectionMode'
92
───
Cause
No mover with Mover 1 magnetic
plate set on the system
More than one mover with Mover 1
magnetic plate set on the system
Controller enable for a mover before
mover 1 was found
Change of the 'MoverIdDetection-
Mode' while MoverID detection is run-
ning
eXtended Transport System
Number of the solution
Version: 1.0
20
20
21
22
Advertisement
Table of Contents
