Beckhoff XTS Hygienic Operating Instructions Manual page 56

Mechanical installation
3
2
1
1
2
56 ───
► Screw in the screws with sealing rings 2 on the straight module 1
1
hand tight
► Mount the other screws with sealing rings on the straight mod-
ules in the same way, except on the two straight modules with
overlapping seals
► After assembly, check that the screws are seated correctly and
flush and correct them if necessary
2
► Cut diagonally through both ends 3 of the overlapping seals 1
and 2 with a cutting tool
A scalpel or a hobby knife, for example, is a suitable cutting tool.
► Cut all three further overlapping seals to length in the same way
1
► Apply adhesive to one end 1
► Press the end into the groove in order to glue the two ends to-
gether
► Remove surplus adhesive with a lint-free cloth
► Glue all three further cut seals in the same way
► Screw in all screws with sealing rings 1 and 2 on the two remain-
ing modules hand tight
eXtended Transport System Version: 1.0