Beckhoff XTS Hygienic Operating Instructions Manual page 55

1
2
1
2
1
Version: 1.0
► Mount the long end of seal 2 on the other side of the curved
module 1 in the same way
► Screw in the screws of the curved module hand tight in order to
fix the seals on both sides
Allow the seal legs to overlap
When assembling, the long legs of the seals must overlap the
short end. The seal parts will be shortened and glued at a later
time.
► Press the long leg 3 of the seal in between the straight mod-
ules 1 and the machine bed 2 with your fingernail
► To facilitate mounting, lift or move the modules slightly
Long legs overlap the short end.
► Mount the long legs of the seal on the other side of the system in
the same way
3
► Insert locating pin 1 at an angle between the straight modules,
then swivel it into the groove 2
► Mount all further locating pins between the straight modules in
the same way
2
Do not fix the modules with overlapping seal
The two straight modules on which the seals overlap on both
sides must not be fixed yet.
eXtended Transport System
Mechanical installation
─── 55