Beckhoff XTS Hygienic Operating Instructions Manual page 61

1
2
1
1
2
Version: 1.0
Align the rails to fit the modules
The guide rails must be mounted on the modules in a certain
alignment. To do this, position the bore holes in the rails over the
tapped holes in the modules.
If the alignment is wrong, the screws will not mate with the
tapped holes in the modules and cannot be screwed in.
► Place the guide rail 2 straight onto the locating pins in the upper
modules
► Then place the lock 1 straight onto the locating pins
► Screw in the screws with sealing rings 1, leaving only a minimal
gap, in order to fix guide rail and lock
► Assemble the lower guide rail in the same way, securing the
guide rail with your hand until the screws have been screwed in
Simple gluing of the seal ends
During the assembly, the ends of the seals between modules and
rails must be glued. For simple and exact gluing, begin with the
insertion of the seals approximately in the center on a module
and the center of a straight guide rail.
► When mounting the seals between modules and rails, make sure
that the flat side 1 faces outwards and the round side 2 inwards
► Make sure that all seals are mounted flush with the system com-
ponents
► Avoid tensile stress on the seals
eXtended Transport System
Mechanical installation
─── 61