Beckhoff XTS Hygienic Operating Instructions Manual page 65

3
1
2
1
Version: 1.0
► Push curved rail 1 carefully onto curved module 2
► Make sure that the seal remains in place
1
2
► Screw the screw with sealing ring 2 in the center of the curved
1
rail hand tight in order to press the curved rail completely against
the curved module
► Then screw in the other screws with sealing rings 1 and 3 hand
tight
2
► Loosen the fixed screws 1 in the upper guide rail somewhat in
order to mount the ends of the seals
► Mount the second curved rail with seals in the same way
The ends of the seals overlap at the starting points.
► Cut diagonally through both ends 2 of the overlapping seals 1
and 3 with a cutting tool
A scalpel or a hobby knife, for example, is a suitable cutting tool.
► Cut the seal on the other side of the system to length in the
3
same way
► Loosen the screws in the upper guide rail somewhat in order to
glue the seals
eXtended Transport System
Mechanical installation
─── 65