Beckhoff XTS Hygienic Operating Instructions Manual page 14

For your safety
During operation
2.1.2
14 ───
Do not use damaged components
Observe the specifications in the technical data during storage,
transport and operation. Do not use damaged components.
Risk of injury when handling cutting tools
You can sustain cutting or puncturing injuries through careless work-
ing with cutting tools.
Ensure safe working. Wear protective gloves if necessary.
Risk of injury when handling adhesives
Adhesive can irritate the eyes, the respiratory organs and the skin.
Do not inhale the vapor. Avoid contact of the adhesive with the eyes
and skin. If adhesive should get into your eyes, immediately rinse
out your eyes thoroughly with water and consult a doctor.
Refer to the manufacturer's documentation when handling adhe-
sives. Wear protective gloves and safety glasses if necessary.
Check safety pictograms
Check whether the designated pictograms are on the product. Re-
place missing or illegible stickers.
Observe tightening torques
Install connections and components in compliance with the specified
tightening torques and check them regularly.
Earth electrical components or modules correctly
Do not touch electrical components or modules unless you are
wearing protective ESD clothing. Only walk on conductive floors.
Only use original packaging for further processing
When shipping, transporting, storing and packing, use the original
packaging or conductive materials.
Observe the earthing concept
Special conditions need to be observed for the earthing of the XTS.
In every case, read the chapter: "Earthing of the supply".
Do not work on live electrical parts
Ensure that the protective conductor is connected properly. Never
disconnect electrical connections while they are live. Only work on
the XTS when the voltage has dropped to < 10 V. Disconnect all
components from the mains and secure against reconnection.
Do not touch hot surfaces
Check cooling of the surfaces with a thermometer. Do not touch the
components during operation. Allow the components to cool down
for at least 15 minutes after switching off.
eXtended Transport System Version: 1.0