Beckhoff XTS Hygienic Operating Instructions Manual page 53

1
2
1
1
Version: 1.0
Make sure the seals are seated correctly
Make sure that the O-ring contours are seated correctly in the in-
tended grooves.
If seals are mounted improperly, fluid can penetrate into the elec-
trical interfaces and damage the system.
► Insert seal 1 at the electrical interface, pressing the O-ring con-
tours fully into the grooves
► Press the seal end 2 carefully into the groove between the ma-
chine bed and the modules
► Remove the surplus Vaseline in the area of the connector with a
lint-free cloth
► Mount all other seals on the electrical interfaces in the same way
Simplified assembly
Initially insert only the locating pins between the curved modules
and straight modules in order to facilitate the mounting of the
seals between the machine bed and the modules. The locating
pins between the straight modules are mounted later.
► Insert locating pin 1 at an angle between the curved module and
the straight module, then swivel it into the groove 2
► Mount the three other locating pins between the curved modules
and the straight modules in the same way
2
► When mounting the seals between the machine bed and the
modules, make sure that the flat side 1 faces outwards and the
round side 2 inwards
► Make sure that all seals are mounted flush with the system com-
ponents
► Avoid tensile stress on the seals
2
eXtended Transport System
Mechanical installation
─── 53