Table of Contents
Advertisement
ModuLab XM ECS Electrochemical System: Installation Guide
2.10
REBOOTING THE SYSTEM
If, for any reason, the ModuLab XM system needs to be rebooted (for example
after a firmware upgrade, or after a network cable has been temporarily
disconnected), proceed as follows:
1. Close down the ModuLab XM ECS software.
2. Switch off the mains supply to the ModuLab XM chassis.
3. Wait five seconds, then switch the ModuLab XM chassis back on again and
wait until the power LEDs stop flashing.
4. Restart the ModuLab XM ECS software.
5. Make sure the system is working correctly. Depending on the reason for having
to reboot, this might involve repeating the communications check or some of
the installation tests.
21006002_AD 11/06/14
Section 2.7, Checking the System Communications.
Chapter 3, Installation Tests.
Assembling the System
2-33
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Solartron Analytical ModuLab XM ECS and is the answer not in the manual?
Questions and answers