Ametek Solartron Analytical ModuLab XM ECS Installation Manual page 65

ModuLab XM ECS Electrochemical System: Installation Guide
5. Close the ModuLab XM ECS software, but leave the Web page open.
6. Click on the
follows:
NOTE:
7. Type the new IP Address, using the recommended values, then click the
Submit

CAUTION:
21006002_AD 11/06/14
Ethernet button to display the
The Reset button restores the fields to their current values,
cancelling whatever has been typed.
button.
Default IP addresses, Table 2-2, Section 2.3, or alternative IP addresses,
Table 2-3, Section 2.9.2.
Contact your system administrator if you wish to change the
subnet mask or gateway address. The subnet mask must be
the same for the PC and chassis, and the gateway address
should normally be left at the default value of 0.0.0.0.
Assembling the System
Ethernet Configuration page as
2-29