Ametek Solartron Analytical ModuLab XM ECS Installation Manual page 6

General Safety Precautions (continued from previous page)
Symbol
NOTES, CAUTIONS AND WARNINGS
For the guidance and protection of the user, Notes, Cautions and Warnings
appear throughout the manual. The significance of these is as follows:
NOTES
CAUTIONS
WARNINGS
AVOID UNSAFE EQUIPMENT
The equipment may be unsafe if any of the following statements apply:
• Equipment shows visible damage.
• Equipment has failed to perform an intended operation.
• Equipment has been stored in unfavourable conditions.
• Equipment has been subjected to severe physical stress.
If in any doubt as to the serviceability of the equipment, don't use it. Get it
properly checked out by a qualified service technician.
LIVE CONDUCTORS
When the equipment is connected to its measurement inputs or supply, the
opening of covers or removal of parts could expose live conductors. The
equipment must be disconnected from all power and signal sources before it is
opened for any adjustment, replacement, maintenance or repair. Adjustments,
maintenance or repair must only be done by qualified personnel, who should
refer to the relevant maintenance documentation.
EQUIPMENT MODIFICATION
To avoid introducing safety hazards, never install non-standard parts in the
equipment, or make any unauthorised modification. To maintain safety, always
return the equipment to your Solartron service provider for service and repair.
iv
Meaning
Safety hazard involving heavy weights. A numerical value for the
amount of weight may appear alongside this symbol. Take care when
handling and carrying. Follow the manufacturer's instructions, and ask
for assistance if necessary.
highlight important information for the reader's special attention.
guide the reader in avoiding damage to the equipment.
guide the reader in avoiding a hazard that could cause injury or
death.
21006002_AD 11/06/14