Ametek Solartron Analytical ModuLab XM ECS Installation Manual page 55

ModuLab XM ECS Electrochemical System: Installation Guide
• Advanced. This feature enables you to change the address of the chassis
display panel hardware, and should normally only be used if there is a
conflict of addresses within the system.

10. Click on a potentiostat group, for example
navigation panel, to display the
This screen enables you to specify a name for the potentiostat group and make
some comments, and then there are IP address fields and
potentiostat and FRA.
11. If an FRA is fitted, and is required for experiments, make sure the
box is checked. This should be checked by default, if an FRA is detected when
the system searches for equipment (Step 6).
12. Make sure the addresses are correct for the potentiostat and the FRA if fitted. If
a module uses the default address based on the slot number, select the
default address?
box unchecked and make sure the address in the four-part field is correct.


13. Click the appropriate
• If an FRA is present, click the
whole group, including the potentiostat, FRA and any other optional
modules, and will set the addresses of the potentiostat and FRA within the
ModuLab XM software.
• If an FRA is not present, click the
test the potentiostat and all optional modules, and will set the address for
the potentiostat within the ModuLab XM software, but will not look for an
FRA.
21006002_AD 11/06/14
Section 2.9.2, Hardware IP Addressing.
check box. Otherwise, if it has a different address, leave the
Table 2-2, Section 2.3, Default IP Addresses for ModuLab XM.
Section 2.9, Advanced Setup, in case alternative addresses are required.
Test button for the potentiostat or FRA as follows:
Pstat Group
Potentiostat Group Setup
Test button for the FRA. This will test the
Test button for the potentiostat. This will
Assembling the System
1, in the left-hand
as follows:
Test buttons for the
FRA present
Use
2-19