Filters; Optional Filters; Dust Air Filter - Christie M Series Setup Manual

4 Maintenance
4.1

Filters

4.1.1 Optional Filters

Dust Air Filter

Monthly
CHECK:
Check projector air dust filters, at minimum, every month.
Dust air filters (if fitted), should be replaced whenever the lamp is replaced or between 200-500 hours,
depending on use. A clogged air filter reduces air flow and can lead to overheating and failure of the projector.
Check monthly by inspecting its color through the side vent grille with a flashlight. Replace grey colored
filters. Leave the filters in their sealed packaging until ready for use.
Replace Filters:
1. Unscrew the 2 captive screws at the top of each filter
door (Figure
away from the projector.
2. Slide the air filter out and replace, vacuum or wash
the filter. Wash using mild soap and water.
Dry the filter before using.
3. Insert the new or cleaned air filter(s).
4. Secure the filter door by tightening the 2 captive
screws loosened in Step 1.
M Series Setup Guide
020-100011-04 Rev. 1 (07-2010)
Use only special, high efficiency Christie approved filters.
This projector is not equipped with fan finger guards. Keep fingers away from the fan
blades when replacing filter.
4-1). Allow the door to rest down and
NOTE:
F 4-1 R F
IGURE EPLACE ILTER
4-1