Routing At The Top; Routing Cables - Huawei UPS5000-E Series User Manual

UPS5000-E-(50 kVA-125 kVA)
User Manual (Integrated UPS 3.0)



Procedure
Step 1 Install the battery cabinet and batteries.
For details, see the battery installation guide delivered along with the batteries.
----End

3.2.4 Routing at the Top

3.2.4.1 Routing Cables



Step 1 Remove five rodent-proof meshes and cable hole protection panels from the top of the
cabinet.
Figure 3-20 Removing rodent-proof meshes
Issue 09 (2019-12-20)
Before installing batteries, read through the battery safety precautions, obtain the delivered
battery installation guide, and install batteries as instructed.
Place the batteries in a correct way to prevent vibrations and shocks.
Install the batteries from the lower layer to the upper layer to prevent falling over due to
imbalance.
The basic rule for routing cables is: from inside out and from bottom up.
When connecting the mains input power cable, strip the outer layer of the 5-wire cable,
wrap each wire in the stripped section using corrugated pipes, and secure the corrugated
pipes using insulation tape to prevent sliding.
You can drill holes in the removed covers as required before reinstalling them on the cabinet.
Copyright © Huawei Technologies Co., Ltd.
3 Installation
75