Configure Network Settings - Cisco Unified IP Phone 8941 Administration Manual

Configure Network Settings

• To enter letters by using the keypad, use a corresponding number key. Press the key one or more times
• To enter a period (for example, in an IP address), press star (*) on the keypad.
• Press the up arrow on the Navigation bar to move the cursor to the left most character, and press the
• Press
• Press Cancel before pressing Save to discard any changes that you have made.
The Cisco Unified IP Phone provides several methods you can use to reset or restore option settings, if
Note
necessary.

Configure Network Settings

The Network Setup menu provides options to view and make a variety of network settings. The following
table describes these options and, where applicable, explains how to change them.
Table 7: Network Setup Menu Options
Option
IPv4 Setup
Host Name
Domain Name
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0
(SCCP and SIP)
32
to display a particular letter. For example, press the 2 key once for "a," twice quickly for "b," and three
times quickly for "c." After you pause, the cursor automatically advances to allow you to enter the next
letter.
down arrow on the Navigation bar to move the cursor to the right most character.
if you make a mistake. This softkey deletes the character to the left of the cursor.
Description
In the IPv4 Setup submenu, you can do the
following:
• Enable or disable the phone to use the
IP address that is assign by the DHCP
server.
• Manually set the IP Address, Subnet
Mask, Default Routers, DNS Server,
and Alternate TFTP servers.
Note
Unique host name assigned to the phone.
Name of the Domain Name System (DNS)
domain in which the phone resides.
You must enter the Alternate
TFTP and TFTP server settings
when you configure an
off-premises phone for SSL VPN
to ASA using a built-in client.
To change
Set Up IPv4, on page 34
Display only—Cannot configure.
Set Domain Name Field, on page 36