Configure The Audio Settings - Cisco 8851 Administration Manual

c = is the index of the desired cadence to play the given waveform. 8 cadences (1–8) as defined in <Cadence
1> through <Cadence 8>. Cadence-id can be 0 If w=3,4, or an url. Setting c=0 implies the on-time is the
natural length of the ring tone file.
b = break-time that specifies the number of seconds to break between two bursts of ring tone, such as b=2.5.
t = total-time that specifies the total number of seconds to play the ring tone before it times out.

Configure the Audio Settings

The user can modify volume settings by pressing the volume control button on the phone, then pressing the
Save softkey.
Procedure
Step 1
Click Admin Login > advanced > Voice > User.
Step 2 In the Audio Volume section, configure a volume level between 1 and 10, with 1 being the lowest level:
• Ringer Volume—Sets the ringer volume.
• Speaker Volume—Sets the volume for the full-duplex speakerphone.
• Headset Volume—Sets the headset volume.
• Handset Volume—Sets the handset volume.
• Electronic HookSwitch Control—Enables or disables the EHS feature.
Step 3 Click Submit All Changes.
User Access Control
The Cisco IP Phone respects only the "ua" user access attribute. For a specific parameter, the "ua" attribute
defines access by the user account to the administration web server. If the "ua" attribute is not specified, the
phone applies the factory default user access for the corresponding parameter. This attribute does not affect
access by the admin account.
The value of the element attribute encloses within double quotes.
Note
The "ua" attribute must have one of the following values:
• na – no access
• ro – read-only
• rw – read/write
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
Configure the Audio Settings
143