Transmission Drive Bolt; Calibration For Unlisted Seeds - Landoll Brillion SL10 Operator's Manual

OPERATION

Transmission Drive Bolt

NOTE
#550 Chain connects Front Roller #550 Chain 6 Tooth
Sprocket with Transmission #550 Chain 13 Tooth
Sprocket.
Transmission Drive Bolt (1/4-20 x 2-1/4) from the #550
Chain 13 Tooth Sprocket, must be removed for
Calibration and can also be removed if it is desired to
use the Seeder as a Pulverizer, Rollers only. (The Acre
Meter will not register when the Bolt is removed). See
Figure 3-12.
Transmission
#550 Chain
6 Tooth Sprocket
#550 Chain
Front Roller
#550 Chain
19 Tooth Sprocket
Figure 3-12: Transmission Drive Bolt
3-10

Calibration for Unlisted Seeds

Brillion/Landoll assumes no liability pertaining to Seeding
Rates achieved with this Seeder. Rates listed are general
in nature and should be used as starting points only.
Seed varieties and blends listed represent those
calibrated through in-house test meters.
Variations in actual rates may be realized due to
differences in Seed Lots. For accurate rates with seeds
being used, follow the Calibration Instructions listed
on the Seed Chart inside the Seed Box Cover.
The information listed in the Seed Charts is subject to
change without notice.
Drive Bolt,
1/4-20 x 2-1/4
Rates are for the 13 Tooth Driver. Double these
values for the 26 Tooth Driver. See Figure 3-11.
Front Seed Box may be Calibrated for Unlisted Seed
as follows.
1. Remove Transmission Drive Bolt (1/4-20 x 2-1/4)
2. Raise Seeder and install Transport Locks. See
3. Close Rear Seed Box openings if they contain Seed.
4. Place a Canvas or Tarp under the Machine to catch
5. Turn 15/16 Hex on Transmission Shaft
6. Weigh Seed (lbs) and Multiply by 10 (20 for 26 Tooth
NOTE
IMPORTANT
from the #550 Chain 6 Tooth Sprocket. See
Figure 3-12.
Figure 3-5.
Seed.
Clockwise(CW). See Figure 3-13.
8FT Seeder: Use 136 turns if you follow Step 6.
Reference, the Seed Shaft rotates 1,360 Revolutions
per Acre Seeded with 13 Tooth Driver.
10FT Seeder: Use 109 turns if you follow Step 6.
Reference, the Seed Shaft rotates 1,090 Revolutions
per Acre Seeded with 13 Tooth Driver.
12FT Seeder: Use 91 turns if you follow Step 6.
Reference, the Seed Shaft rotates 910 Revolutions
per Acre Seeded with 13 Tooth Driver.
Driver) for approximate Planting Rate in Pounds per
Acre.
1P342-0621