Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
NOTE: IF REPAIRING OR REPLACING THE 7 PIN
CONNECTOR, MATCH THE LETTERS AT THE
BACK OF THE HARNESS TO THE 7 PIN CONNECTOR
AS SHOWN. THE COLOR OF THE WIRE JACKET
DOES NOT NECESSARILY MATCH THE COLOR
MARKING OF THE 7 PIN CONNECTOR.
#1 WHITE
#2 BLACK
#3 YELLOW
FACING 7-PIN CONNECTOR
Figure 3-20: Light and SMV Bracket Installation (Prior to August, 2013)
Light Installation (Prior to
August, 2013)
NOTE
See Figures 2-1 thru 2-16 for light bracket placement. If
no dimension is given for a bracket, it should be located
against frame member as shown in drawing.
1. Attach inner tail light mounting bracket supports to
the center frames using 1/2-13 x 8-1/2 hex head cap
screws, warning light bars, and hex lock nuts (See
Figure 3-19.)
2. Connect enhanced lighting module to the right inner
tail light bracket using #8-32 x 1/2 slotted pan head
screws and hex nut.
3. Attach outer lh and rh light brackets to frame
weldment using 1/2-13 x 5-1/2 hex head cap screws,
warning light bars, and hex lock nuts.
3-28
#7 BLUE
#6 BROWN
#5 GREEN
#4 RED
IMPORTANT
Outer light brackets need to be slid rearward as far
as possible. See Figures 2-1 thru 2-16 for light
bracket placement.
4. Attach red brake lamps to inner tail light mounting
5. Connect warning light harnesses to lights.
6. Attach SMV emblem and mounting bracket to rear
7. Attach red, orange, and yellow reflectors to outer rh
7-PIN
CONNECTION
GRND. 1
YEL. 3
GRN. 5
BRN. 6
bracket supports and amber lamps to outer light
brackets using 1/4-20 x 1-1/4 and 1/4-20 x 1-1/2 hex
head cap screws and hex lock nuts.
center frame bar using warning light bar, 1/2-13 x
5-1/2 hex head cap screws, 1/4-20 x 3/4 hex head
cap screws, and hex lock nuts. The SMV sign should
be centered on the rear bar of the frame.
and lh tail light mounting brackets.
WIRING CHART
4-PIN
CONNECTION
D
B
A
C
F-721-0513
Advertisement
Table of Contents
