Table of Contents
Advertisement
NOTE: IF REPAIRING OR REPLACING THE 7 PIN
CONNECTOR, MATCH THE LETTERS AT THE
BACK OF THE HARNESS TO THE 7 PIN CONNECTOR
AS SHOWN. THE COLOR OF THE WIRE JACKET
DOES NOT NECESSARILY MATCH THE COLOR
MARKING OF THE 7 PIN CONNECTOR.
#1 WHITE
#2 BLACK
#3 YELLOW
FACING 7-PIN CONNECTOR
electrical connector op
Figure 3-12: 7 Pin Connector Detail and Wiring Chart (Prior to August, 2013)
Light Installation (Prior to
August, 2013)
NOTES
• See Figures 2-1 thru 2-3 for light bracket placement.
If no dimension is given for a bracket, it should be
located against frame member as shown in drawing.
• See Figure 3-10 for Light and SMV Bracket
Installation for 2410-7-24 model.
• See Figure 3-11 for Light and SMV Bracket
Installation for 2410-6-24 and 2410-9-24 models.
1. Attach inner tail light mounting bracket supports to
the center frames using 5/8-11 x 9-1/2 hex head cap
screws, light mount bracket, and hex lock nuts (See
Figures 3-10 and 3-11.)
2. On 2410-7-24 model, attach amber lamps and outer
LH and RH light brackets to frame weldment using
1/4-20 X 1-1/4 hex head cap screws and hex lock
nuts.
#7 BLUE
#6 BROWN
#5 GREEN
#4 RED
3. On 2410-6-24 and 2410-9-24 models, attach outer
4. On 2410-6-24 and 2410-9-24 models, attach amber
5. Attach red brake lamps to inner tail light mounting
6. Connect warning light harnesses to lights.
7. Attach SMV emblem and mounting bracket to rear
ASSEMBLY INSTRUCTIONS
7-PIN
CONNECTION
GRND. 1
YEL. 3
GRN. 5
BRN. 6
LH and RH light brackets to frame weldment using
1/2-13 x 9-1/2 hex head cap screws and hex lock
nuts.
lamps to the light brackets using 1/4-20 x 1-1/4 hex
head cap screws and hex lock nuts.
bracket supports using 1/4-20 x 1-1/4 hex head cap
screws and hex lock nuts.
center frame bar using warning light bar, 1/2-13 x
5-1/2 hex head cap screws, 1/4-20 x 3/4 hex head
cap screws, and hex lock nuts. The SMV sign should
be centered on the rear bar of the frame.
WIRING CHART
4-PIN
CONNECTION
D
B
A
C
3-19
Advertisement
Table of Contents
