Tractor Preparation; Disc Preparation - Landoll 6250 Operator's Manual

OPERATION AND MAINTENANCE

Tractor Preparation

The Landoll 6250 Disc is designed to be pulled by tractor
equipped with a double lip or clevis type hitch CAT IV or
V. If your tractor is not equipped as such, you need to
purchase the hitch from your local tractor dealer.
Before attaching the Disc, prepare the tractor as follows:
1. Inflate the rear tractor tires equally and add ballast
according to the tractor operator's manual.
2. Lock the tractor drawbar in the center position.
4-2

Disc Preparation

6250 scraper adj
Figure 4-1: Disc Scraper to Disc Blade
1. Prior to operating the 6250 Disc, inspect it thoroughly
for good operating condition.
2. Replace worn or missing parts.
3. When the machine is new, check the bolt tightness
after a few hours of operation. Tighten any loose nuts
or bolts. Check the lift wheel lug bolts daily.
4. Check the lift wheel tire inflation. Inflate all tires
equally to avoid side draft. Follow the tire
manufacturer's recommended pressures listed on the
sidewall of the tires.
5. Check disc scrapers for proper adjustment to the disc
blade (See Figure 4-1.)
6. Lubricate the machine as shown in "Lubrication
Maintenance" on page 4-24 (See Figure 4-25.)
1/8"
F-733-1114