Table of Contents
Advertisement
HOOKUP AND OPERATION
Tractor Preparation
The Landoll/Icon AG11/13 is designed to be pulled by a
tractor equipped with a double lip or clevis type hitch. If
your tractor is not equipped as such, you need to
purchase the hitch from your local tractor dealer.
Before attaching the AG11/13, prepare the tractor as
follows:
1. Inflate the rear tractor tires equally and add ballast
according to the tractor operator's manual.
2. Lock the tractor drawbar in the center position.
AG11/13 Preparation
1. Prior to operating the AG11/13, inspect it thoroughly
for good operating condition.
2. Replace worn or missing parts.
3. When the machine is new, check the bolt tightness
after a few hours of operation. Tighten any loose nuts
or bolts. Check the lift wheel lug bolts daily.
Check the air inflation of all tires. Follow the tire
4.
manufacturer's recommended pressure listed on
the sidewall of the tires.
5. Lubricate the machine as shown in
Schedule" on page 3-2 ,See Figure 3-1
4-2
TABLE OF CONTENTS
Attaching to the Tractor
1. Align the tractor drawbar with the machine. Raise or
2. Always place the swivel jack on the interior mount
3. Clean all hydraulic couplings and attach to the
4. Attach safety chain to tractor allowing plenty of
5. Plug in the 7-pin connector for the lights.
NOTE
The lighting system requires a good ground connection
"Lubrication
and if the lights do not seem to work right check the
installation of the 7-pin connector and the condition of the
pins.
Hydraulic Lift System
The AG11/13 is equipped with a hydraulic lift system to
raise and lower the unit in the field.
lower the unit ring hitch, as needed, using the swivel
jack. Attach the unit with proper size hitch pin.
before setting the machine in motion.
tractor.
movement for turning both directions. The safety
chain should latch securely to prevent it coming
loose.
a. The tractor should have a good clean receptacle,
free of dirt and corrosion.
b. Make sure the 7-pin connector is inserted all the
way in, and allows the cover to latch over the
keyway to secure it in place.
Figure 4-2: Hydraulic Leak Detection
INDEX
F-879-1219
Advertisement
Table of Contents
