Tractor Preparation/Attaching Of Pull Type Seeder - Landoll Brillion SL10 Operator's Manual

Tractor Preparation/Attaching of
Pull Type Seeder

Do not allow any bystanders to stand between
the tractor and the machine while backing up to
the machine.
1. Align the Tractor Drawbar with the machine. Raise or
lower the Drawbar, as needed, using the Jack.
Attach the unit with proper size Hitch Pin and Safety
Clip.
2. Always move the Jack to the transport position
before setting the machine in motion.
3. Clean all Hydraulic Couplings and attach to the
Tractor.
4. If Transport Locks are not engaged, fully extend the
Hydraulic Lift Cylinders and rotate Transport Locks in
the engaged position over the Cylinder Rods. Secure
with the Clevis Pins and Hairpin Cotters. See
Figure 3-5.
IMPORTANT
If the Clevis Pin is not installed, the Transport Lock
may bounce up and cause significant damage to the
Cylinder and Hydraulic Fittings.
Wheel Arm
Clevis Pin
Figure 3-5: Transport Lock Engaged
5. Attach safety chain to tractor allowing plenty of
movement for turning both directions. The safety
chain should latch securely to prevent it from coming
loose. See Figure 3-6.
1P342-0621
DANGER
Frame
Cylinder
Engaged
Transport Lock
Hair Pin
Cotter
Locknut, 3/4-10
Drawbar
Tractor Drawbar
Support
Safety Chain
Intermediate
9" Max.
Support
Figure 3-6: Safety Chain
6. Connect the 7-Pin Connector to Tractor Outlet,
routing cable by avoiding pinch points.
• Make sure the Tractor has a good clean
Receptacle, free of dirt and corrosion.
• Make sure the 7-Pin Connector is inserted ALL the
way in. With tighter fitting pins, operator may think
the Connector is all the way in, but really isn't.
• Make sure the Tractor Receptacle Cover latches
over the keyway on the 7-Pin Connector to hold
the Connector in place.
• If an operator plugs in the 7-Pin Connector, but the
lights do not seem to work right, check the above
items to make sure there is a good connection with
the 7-Pin Connector.
OPERATION
Flat
Washer, 3/4"
Bolt,
3/4-10 x 2-1/4
Safety Chain
3-5