Table of Contents
Advertisement
OPERATION AND MAINTENANCE
Attaching Grain Drill To The
Tractor - Pull Hitch (Optional)
The Grain Drill has positive and negative tongue
weight. Use a locking-style hitch pin that is
properly sized for the tractor drawbar and
implement hitch.
1. Make sure the tractor drawbar is rated and adjusted
properly for the weight of the drill hitch.
2. Measure the tractor drawbar and adjust the hitch
clevis to the appropriate hitch mounting holes.
3. Carefully back the tractor into position. Raise or lower
the hitch with the jack to achieve the proper hitch
height.
Figure 4-6: Hydraulic Leak Detection
4. Back the tractor into final position, and install the
hitch pin.
5. Lower and remove the jack. Place jack in the storage
location in the middle of the hitch
6. Plug the safety lights into the seven-pin connector on
the tractor.
7. Attach the safety chain to an anchor on the tractor.
Refer to tractor manual for proper placement.
8. Connect the hydraulic hoses to the tractor.
4-4
WARNING
See Figure
Escaping fluid under pressure can penetrate the
skin causing serious personnel injury. Avoid the
hazard by relieving system pressure before
disconnecting hydraulic lines. Tighten all
connections before applying pressure. Keep
hands and body away from pinholes which eject
fluid under high pressure. Wear protective
gloves and safety glasses when working with
hydraulics. Use a piece of cardboard or paper,
not body parts to search/check for leaks. If an
accident occurs, see a doctor immediately. Any
fluid injected into the skin must be surgically
removed within a few hours or gangrene may
result.
9. Fully raise the Grain Drill and install the transport
locks. Place parking stands in Transport/Planting
position
See Figures 4-2
Transport Locks - Pull Hitch
1. Transport lock pins are provided to secure the Grain
Drill in raised position. Do not depend on hydraulics
when working beneath raised equipment or when
transporting.
Install both transport locks before attempting to
service, adjust, or transport raised equipment.
2. The transport locks are installed on the holders
located on the hitch when not in use
4-7.
To install the transport locks:
a. The hitch clevis must be attached to the tractor.
Then fully raise the hitch of the Grain Drill.
b. Remove the L-pins and hairpin clips from the
stored transport locks.
c. Slide the transport locks over the extended
cylinder shafts.
d. Reinstall the L-pins and hairpin clips to secure
the transport locks to the cylinder shafts.
IMPORTANT
Failure to install/remove BOTH transport locks will
result in damage to the grain drill.
3. To remove the transport locks:
a. The hitch clevis must be attached to the tractor.
b. Fully raise the Grain Drill to remove any weight
setting on the transport locks.
WARNING
and
See Figures
WARNING
See Figure
F-1058-0820
4-4.
4-7.
Advertisement
Table of Contents
