Rear Jack Installation - Landoll 2211 Operator's Manual

Rear Jack Installation

A rear jack assembly is used on the rear of the 2211-13 &
-15 Disc Chisel models and is an option on the 2211-09 &
-11 models. This is extremely helpful if an attachment has
been added to the rear of the machine for stability.
1. Attach rear jack mount and rear jack plate to the rear
frame of the Disc Chisel using 3/4-10 x 4 hex head
cap screws and hex lock nuts (See Figure 3-26.)
IMPORTANT
The rear jack tube should be located to the rear of the
Disc Chisel near the center of the frame.
2. Slide rear jack square tube into rear jack mount from
the bottom and hold in desired location with wing lock
pin, 1/4 x 3 slotted roll pin, and 3/16 hair pin.
3. Attach jack mount tube to rear jack square tube using
3/4-10 x 4 hex head cap screw and hex lock nut.
ASSEMBLY INSTRUCTIONS
3/4-10 X 4 HEX HEAD
CAP SCREW
3/4W FLAT WASHER
REAR JACK MOUNT
WING LOCK
PIN
3/16 HAIR PIN
3/4-10 HEX LOCK NUT
REAR JACK PLATE
REAR JACK
SQUARE TUBE
3/4-10 X 4 HEX HEAD
CAP SCREW
m160600 op
Figure 3-26: Rear Jack Installation
1/4 X 3 SLOTTED
ROLL PIN
3/4-10 HEX
LOCK NUT
JACK MOUNT
TUBE
3-29