Table of Contents
Advertisement
LED Light and SMV Bracket
Installation
1. Attach lights and mounting brackets to the center
frames using u-bolts, 3/4-10 x 6 hex head cap
screws, hex nuts, and hex lock nuts (See
Figure 3-22.) Refer to pages 2-6 thru 2-11 for light
bracket placements.
2. Attach ag amber single LED lamps to light brackets
using 1/4-20 x 1-1/4 hex head cap screws and hex
lock nuts.
3. Attach left tail light mount to frame assembly using
u-bolt and 5/8-11 flange head serrated nuts.
4. Attach right tail light mount and ag flasher control
module to frame assembly using u-bolt and 5/8-11
flange head serrated nuts. Be sure that the control
module is set so that the 6 pin connector faces the
right side of the machine.
5. Attach the ag red single LED lamps to tail light
mounts using 1/4-20 x 1-1/4 hex head cap screws
and hex lock nuts.
ASSEMBLY INSTRUCTIONS
IMPORTANT
Make sure lights are positioned for maximum
visibility from the rear.
6. Install the rear warning light harness to the frame.
Connect 2 pin and 3 pin ends to each of the warning
lights. Connect 6 pin to the ag flasher control module.
See Figure 3-22 for LED harness wire
designations.
7. Attach front warning harness to frame. Connect 4 pin
end to the ag flasher control module.
8. Insure that the harnesses are clear of any moving
parts and secure the harnesses with tie wraps
provided.
9. Install the stor-away holder to hose holder on hitch
with 1/4-20 x 3/4 hex head cap screws and hex lock
nuts.
10. Attach SMV emblem and mounting bracket to rear
center frame bar using u-bolt, 1/4-20 x 3/4 hex head
cap screws, and hex lock nuts. The SMV sign should
be centered on the back bar of the frame.
Rear Tow Hitch Installation
1. Refer to "Parts Manual" for installation of rear tow
hitch.
2. Move SMV from frame to rear tow hitch as shown.
3. If hydraulics are used, route through right side of
hitch tube.
3-25
Advertisement
Table of Contents
