Seed Shaft Sensor Kit - Optional - Landoll Brillion SL10 Operator's Manual

ASSEMBLY

Seed Shaft Sensor Kit - Optional

1. Remove the two #10 x 24 x 3/4" Self Tapping Screws
from the Magnet Wheel Assembly. Position the
rounded half of the Magnet Wheel Assembly on the
seed shaft. Ensure it fits squarely onto shaft. Mount
magnet half to the rounded half. Ensure it fits
squarely onto shaft. See Figure 2-21.
2. Fasten the two halves together using two #10-24 x
3/4" Self Tapping Screws. Do not over tighten.
Seed Shaft
Seed Shaft
Sensor
2-16
Magnet Wheel
Assembly
3/8 Sq Shaft
Machine Screw,
1/4-20 x 3/4
Existing
Lock Washer,1/4-20
Screw,Self Tapping
#10-24 x 3/4
Shaft Sensor
Bracket
Figure 2-20: Seed Box Brackets
3. Identify the seed cups on either side of the Magnet
Wheel Assembly and remove the 1/4-20 hardware.
4. Insert Sensor into Shaft Sensor Bracket slot.
5. Insert a 1/4-20 x 3/4 Machine Screw into each seed
cup. Align the Shaft Sensor Bracket with the two
1/4-20 x 3/4 Screws. Secure with existing Lock
Washers and Nuts.
6. Slide/Position Seed Shaft Sensor so it is 1/8" from
the magnet. See Figure 2-21. Tighten both Retaining
nuts.
Screw,Self Tapping
#10-24 x 3/4
Shaft Sensor
Bracket
Existing
Nut,1/4-20
Magnet Wheel
Assembly
3/8 Sq Shaft
Machine Screw,
1/4-20 x 3/4
Existing
Lock Washer,1/4
Existing
Nut,1/4-20
Seed Shaft
Sensor
Seed Shaft
MidBoxSensorBrkts
1P342-0621