Reel Assembly Service (Cutting Units With Aluminum Side Plates) - Toro Reelmaster 5410 Series Service Manual

Reel Assembly Installation (continued)

Reel Assembly Service (cutting units with aluminum side plates)

Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
13. Install the bedbar assembly; refer to
9–21).
14. Adjust the cutting unit; refer to the Cutting Unit Operator's Manual.
Note: The parallel position of the rear roller to the cutting reel is controlled by
the precision machined frame and side plates of the cutting unit. If necessary,
the cutting unit side plates can be loosened and a slight adjustment can be
made to parallel the rear roller with the cutting reel; refer to
Rear Roller (page
15. Install accessories if equipped. Refer to
for additional belt driven groomer information. Refer to
(page 11–4) for additional universal groomer information. Refer to
Roller Brush – Optional (cutting units with aluminum side plates) (page 9–57)
for additional rear roller brush information.
16. If counterweight was removed from cutting unit, install new O-ring on counter
weight. Secure counter weight to cutting unit side plate with two (2) flange
nuts. Torque screws from 37 to 44 N∙m (27 to 33 ft‐ ‐ ‐ lbs).
17. install cutting unit to the machine.
g230065
1. Cutting reel
2. Threaded insert (right hand thread)
3. Plastic plug (2 each)
4. Retaining ring (2 each)
5. Special washer (2 each)
6. Flocked seal (2 each)
Installing the Bedbar Assembly (page
9–15).
Figure 345
7.
8.
9.
10.
11.
12.
Page 9–39
Leveling the
Service and Repairs (page 10–6)
Service and Repairs
Sealed bearing (2 each)
Threaded insert (left hand threads)
Groove indicating left hand threads
Reel spider
Retaining ring groove
Bearing shoulder
Cutting Unit: Service and Repairs
Rear