Service And Repairs; Hydraulic Reel Motor - Toro Reelmaster 5410 Series Service Manual

Service and Repairs

Hydraulic Reel Motor

Removing the Hydraulic Reel Motor
Installing the Hydraulic Reel Motor
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
When performing the maintenance procedures on the cutting units,
carefully position the cutting unit reel motors to prevent damage to
the motors or hydraulic hoses.
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, shut off the engine, set the parking brake, and
remove the key from the key switch.
g214396
1. Hydraulic reel motor
2. Bolt (2 each)
2. Loosen the 2 bolts (item 2 in
to the cutting unit side plate. Rotate the motor clockwise and remove the
motor from the cutting unit.
3. Place a protective plastic cap (refer to
side plate to prevent unwanted material entering into the reel bearing area.
Check the reel insert splines for wear. Replace the inserts if necessary; refer to
Reel Assembly Service (cutting units with painted side plates) (page 9–33)
(page ).
IMPORTANT
Figure 327
Cutting unit with cast iron side plate
3. Relief vent
4. Grease fitting
Figure 327) that secure the hydraulic reel motor
(page
Page 9–17
)) into the hole in the cutting unit
Cutting Unit: Service and Repairs
or