Rear Wheel Bearings (Machines With 2-Wheel Drive) - Toro Reelmaster 5410 Series Service Manual

Rear Wheel Bearings (Machines with 2-Wheel Drive)

g228650
1. Dust cap
2. Cotter pin
3. Retainer
4. Jam nut
5. Tab washer
Disassembling the Rear Wheel Bearings (Machines with 2-Wheel Drive)
Chassis: Service and Repairs
6. Bearing cone
7. Bearing cup
8. Wheel hub
9. Seal
10. Spindle
1. Chock front wheels to prevent machine from shifting.
2. Remove rear wheel; refer to
with jack stands.
3. Remove the dust cap from the wheel hub.
4. Remove the cotter pin, retainer, jam nut, and tab washer. Slide the wheel
hub from the spindle shaft.
5. Pull the seal out of the wheel hub. Discard seal.
6. Remove the bearing cones from both sides of the wheel hub. Clean the
bearings in solvent. Ensure that the bearings are in good operating condition.
Clean the inside of the wheel hub. Check the bearing cups for wear, pitting or
other damage. Replace worn or damaged parts.
7. Clean spindle surface and check for wear or damage. Replace spindle
if necessary.
Figure 297
11.
12.
13.
Wheels (page
Page 8–14
Flange-head screw (4 each)
Housing
Wheel stud (5 each)
8–5). Ensure to support machine
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C