Cutting Reel Motor - Toro Reelmaster 5410 Series Service Manual

Cutting Reel Motor

g216668
1. #5 hydraulic reel motor
2. O-ring
3. 90° hydraulic fitting
4. O-ring
5. Hydraulic hose
Removing the Cutting Reel Motor
Hydraulic System: Service and Repairs
Reelmaster 5510/5610 series cutting reel motors
6. O-ring
7. Hydraulic fitting
8. O-ring
9. Hydraulic hose
10. Hydraulic hose
Note: Sauer-Danfoss cutting reel motors are used on Reelmaster
5410/5410-G/5410-D machines with serial numbers below 313999999.
Casappa cutting reel motors are used on Reelmaster 5410/5410-G/5410-D
machines with serial numbers above 313999999 and also Reelmaster
5510/5510-G/5510-D/5610/5610-D machines.
1. Park the machine on a level surface, lower the cutting units, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Read the General Precautions for Removing and Installing the Hydraulic
System Components (page
Figure 171
11. Hydraulic hose
12. #3 hydraulic reel motor
13. #2 hydraulic reel motor
14. #4 hydraulic reel motor
15. Hydraulic fitting
6–145).
Page 6–202
16. Hydraulic hose
17. Hydraulic hose
18. Hydraulic hose
19. 90° hydraulic fitting
20. #1 hydraulic reel motor
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C