Lower/Raise Joystick Switches - Toro Reelmaster 5410 Series Service Manual

Lower/Raise Joystick Switches

Electrical System: Testing the Electrical Components
g190998
1. Joystick
g191007
1. Joystick
2. Switch lever
3. Common terminal
The 2 micro switches for the joystick are located on the lower mow/raise lever
that is attached to the control arm
forward, the rear switch on the control is used to lower (and engage) the cutting
units. When the joystick is pulled backward, the front switch is used to raise (and
disengage) the cutting units
open contact in the switch closes when the joystick is positioned to either lower
or raise the cutting units Each switch has an electrical connector to ensure the
normally closed contact on the switch is not used. The raise switch has pink/blue
and black harness wires connected to it and the lower switch has orange/white
and black harness wires connected to it.
The Toro Electronic Controller (TEC) monitors the position of the normally open
lower/raise switches. The lower/raise joystick switches are inputs used by the
TEC to manage various machine functions.
Figure 243
2. Control arm
Figure 244
4. Normally Open (NO)
terminal
5. Normally Closed terminal
(not used)
6. Raise switch
(Figure 243). When the joystick is pushed
(Figure 244). The switches are identical. A normally
Page 7–70
7. Lower switch
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C