Toro Reelmaster 5410 Series Service Manual page 423

Testing the Reel Engage Switch (continued)
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
7. The reel engage switch terminals are identified in
of the switch is shown in the
use of a multimeter (ohms setting), test the switch functions to determine
if continuity exists between the various terminals for each switch position.
Check the continuity between the switch terminals.
Circuit Logic Table
Switch Position
O
N
O
FF
Note: The reel engage switch terminals 1 and 4 are not used on Reelmaster
5010 machines.
8. Replace the reel engage switch if testing determines that the switch is
damaged.
9. If the reel engage switch testing is correct and a circuit problem still exists,
check the wire harness; refer to the Electrical Schematic and Wire Harness
Drawings/Diagrams in
10. After you complete the testing, connect the wire harness connector to the
reel engage switch.
11. Secure the control arm covers to the machine; refer to
Control Arm (page
Circuit Logic Table (page
Normal Circuits
2+3
2+1
Appendix A (page A–1).
8–25).
Page 7–67 Electrical System: Testing the Electrical Components
Figure 240 and the circuitry
7–67). With the
Other Circuits
5+6
5+4
Assembling the