Servicing The Lift Cylinder - Toro Reelmaster 5410 Series Service Manual

Servicing the Lift Cylinder

g217164
1. Grease fitting
2. Retaining ring
3. Wear ring
4. Piston
Disassembling the Lift Cylinder
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
5. BP seal
6. O-ring
7. Shaft
8. Grease fitting
Note: The front, outside lift cylinders are longer with more stroke than the other
lift cylinders which are identical. Service procedures for all lift cylinders used on
Reelmaster 5010 machines are the same.
1. Slowly pump the cylinder shaft to remove the hydraulic fluid from the lift
cylinder into a drain pan. Plug both the ports and clean the outer surface of
the cylinder.
Figure 183
9. Dust seal
10. BS seal
11. Back-up washer
12. O-ring
Page 6–219
13. Head
14. Locknut
15. Barrel
Hydraulic System: Service and Repairs