Backlapping - Toro Reelmaster 5410 Series Service Manual

Backlapping

Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
To Avoid Personal Injury or Death
• Never place hands or feet in the reel area while the engine is
running. Stay away from the cutting reels when backlapping.
• When backlapping, run engine at idle speed only.
• While backlapping, the reels may stall and then restart.
• Do not attempt to restart reels by hand or foot.
• Do not adjust reels while the engine is running.
• If a reel stalls, stop engine before attempting to clear the reel.
• Reel motors are connected in series: rotating one motor causes
rotation in other motors.
Instructions and procedures on backlapping are available in the Traction Unit
Operator's Manual and the Toro General Service Training Book, Reel Mower
Basics (part no. 09168SL).
g251598
1. Top surface
Remove burr (without dulling sharp corner) 4.
2.
For a better cutting edge, run a file across the front face of the bedknife when the
lapping operation is completed. This will remove any burrs or rough edges that
may have built up on the cutting edge.
DANGER
Figure 330
3. Top angle
Front angle
Page 9–19 Cutting Unit: Service and Repairs