Chapter 9: Cutting Unit; Specifications - Toro Reelmaster 5410 Series Service Manual

Cutting Unit Specifications (continued)
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
Bedknife: Replaceable, tool steel EdgeMax™ bedknife is fastened to a
machined cast iron bedbar with 8 screws. Optional bedknives are available.
Bedknife adjustment: Dual screw assemblies allow for precise bedknife
adjustment. Adjustment detents correspond to bedknife movement for each
indexed position as follows:
•
0.018 mm (0.0007 inch) for 5 inch reel
•
0.022 mm (0.0009 inch) for 7 inch reel
Front and rear rollers: Greaseable through-shaft front and rear rollers are used
with these cutting units. All rollers use the same heavy duty, stainless steel ball
bearings and seal package.
Counterbalance weight: A cast iron weight or a groomer and/or a powered
rear roller brush accessory is mounted opposite to the hydraulic drive motor to
balance the cutting unit.
Cutting unit weight (with cast iron side plates) (without counterbalance
weight):
8 Blade, 5 inch reel
11 Blade, 5 inch reel
8 Blade, 7 inch reel
11 Blade, 7 inch reel
Cutting unit weight (with aluminum side plates) (without counterbalance
weight):
8 Blade, 5 inch reel
11 Blade, 5 inch reel
8 Blade, 7 inch reel
11 Blade, 7 inch reel
Options: Refer to the Cutting Unit Parts Catalog for available options for your
Reelmaster cutting unit.
51 kg (112 lb)
52 kg (116 lb)
67 kg (147 lb)
69 kg (151 lb)
41 kg (90 lb)
42 kg (93 lb)
54 kg (118 lb)
55 kg (121 lb)
Page 9–3 Cutting Unit: Specifications