Air Cleaner Assembly - Toro Reelmaster 5410 Series Service Manual

Removing the Air Cleaner Assembly
Installing the Air Cleaner Assembly
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
1. Park machine on a level surface, lower cutting units, stop engine, engage
parking brake and remove key from the key switch. Raise and support hood.
2. Remove air cleaner components as necessary
3. Refer to Traction Unit Operator's Manual for air cleaner service and
maintenance procedures.
Any leaks in the air filter system will allow dirt into engine and
will cause serious engine damage. Ensure that all air cleaner
components are in good condition and are properly secured during
assembly.
1. Assemble air cleaner system
g229321
1.

Air cleaner assembly

2. Indicator
A. If service indicator (item 6 in
air cleaner housing, apply thread sealant to adapter threads before
installing adapter and indicator to housing. Install adapter so that the
grooves in adapter hex and adapter filter element are installed toward
service indicator
to 15 in-lb).
B. Ensure that evacuator valve on air cleaner assembly is pointed down
after assembly.
IMPORTANT
(Figure 43).
Figure 44
3. Adapter
4. Evacuator valve
Figure 43) and adapter were removed from
(Figure 44). Torque the indicator to 1.4 to 1.6 N∙m (12
Page 5–7 Kubota Gasoline Engine: Service and Repairs
(Figure 43).