Servicing The Rear Wheel Motor (Machine With Crosstrax Awd) - Toro Reelmaster 5410 Series Service Manual

Servicing the Rear Wheel Motor (Machine with CrossTrax AWD)

g186199
1. Dirt and water seal
2. Outer bearing
3. Housing
4. Back-up ring
5. Back-up washer
6. Shaft seal
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
7. Inner bearing
8. Thrust washer
9. Thrust bearing
10. Coupling shaft
11. Thrust bearing
12. Drive link
Note: The rear wheel motors used on machines with the CrossTrax AWD are the
Parker Torqmotor™ motors of the same basic design with minor differences. The
right side motor has a reverse timed manifold to allow correct rotation direction
for forward and reverse. The left side wheel motor is identified with a yellow dot
on the motor housing near the B port.
Note: For the rear wheel motor repair procedures; refer to the Parker
Torqmotor™ Service Procedure (TC, TB, TE, TJ, TF, TG, TH, and TL Series) at
the end of this chapter.
Figure 160
13. Bolt (7 each)
14. End cover
15. Body seal (5 each)
16. Commutator
17. Commutator ring
18. Manifold
Page 6–183
19. Stator
20. Vane (7 each)
21. Wear plate
22. Rotor
23. Commutator ring
Hydraulic System: Service and Repairs