Dielectric Gel - Toro Reelmaster 5410 Series Service Manual

Dielectric Gel

Toro Part No. 107-0342
Use the dielectric gel to prevent corrosion of unsealed
connection terminals. To ensure complete coating of the
terminals, liberally apply the gel to the component and wire
harness connector, plug the connector into the component,
unplug the connector, apply the gel to both surfaces again,
and connect the harness connector to the component again.
The connectors must be fully packed with gel for effective
results.
Note: Do not use the dielectric gel on the sealed connection
terminals as the gel can unseat the connector seals during
assembly.
Electrical System: Special Tools Page 7–8 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C