Headlight Switch - Toro Reelmaster 5410 Series Service Manual

Headlight Switch

Testing the Headlight Switch
Electrical System: Testing the Electrical Components
g190997
1. Control arm
The headlight switch is located on the operator side of the control arm
245). This rocker switch allows the headlights to be turned on and off.
1. Park the machine on a level surface, lower the cutting units, set the parking
brake, and shut off the engine.
2. Remove the left control arm cover to get access to the headlight switch; refer
to Disassembling the Control Arm (page
3. Ensure that the key switch is in the O
electrical connector from the headlight switch.
g223017
4. The headlight switch terminals are identified in
the switch is shown in the
multimeter (ohms setting), test the switch functions to determine if continuity
exists between the various terminals for each switch position. Check the
continuity between the switch terminals.
Circuit Logic Table
Switch Position
O
N
O
FF
Note: The headlight switch terminals 1, 4, 5, and 6 are not used on the
Reelmaster machines.
5. Replace the headlight switch if testing determines that the switch is damaged.
Figure 245
2. Headlight switch
8–23).
position. Disconnect the wire harness
FF
Figure 246
Circuit Logic Table (page
Normal Circuits
2+3
2+1
Page 7–72
(Figure
Figure 246 and the circuitry of
7–72). With the use of a
Other Circuits
5+6
5+4
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C