High Flow Hydraulic Filter Kit; Spindle Plug; Wheel Hub Puller - Toro Reelmaster 5410 Series Service Manual

High Flow Hydraulic Filter Kit

Toro Part No. TOR6011
The high flow hydraulic filter kit is designed with large flow
(150 L/minute or 40 gallons/minute) and high pressure
(34,500 kPa or 5,000 psi) capabilities. This kit provides
for bi-directional filtration which prevents filtered unwanted
material from entering into the circuit regardless of flow
direction.
If a component failure occurs in the closed loop traction
circuit, contamination from the damaged part will remain in
the circuit until you remove it. Install a high flow hydraulic-fluid
filter into the circuit when you connect the hydraulic test
gauges in order to test the traction circuit components or after
you replace a failed traction circuit component (e.g., piston
pump or wheel motor). This filter removes contamination from
the hydraulic fluid in the traction circuit, thereby preventing
additional component damage.
Note: This kit does not include the hoses; refer to
Hose Kit (page 6–45).
Note: The replacement filter element is Toro Part No.
TOR6012. The filter element cannister tightening torque is
34 N∙m (25 ft-lb).

Spindle Plug

Toro Part No. 94-2703
This spindle plug can be used to prevent contaminant entry
into the cutting reel spindle assembly when the hydraulic
motor is removed from the spindle.

Wheel Hub Puller

Toro Part No. TOR6004
The wheel hub puller allows you to safely remove the wheel
hub from the wheel motor shaft.
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
Hydraulic
Page 6–47 Hydraulic System: Special Tools