Rear Roller Brush - Optional (Cutting Units With Aluminum Side Plates) - Toro Reelmaster 5410 Series Service Manual

Rear Roller Brush – Optional (cutting units with aluminum side
plates)
g252763
1. Brush bearing housing (non-driven) 8.
2. Brush bearing housing (drive)
3. O-ring
4. Roller brush shaft
5. Flange nut (4 each)
6. Mounting bracket (2 each)
7. Excluder seal (2 each)
Disassembling the Rear Roller Brush
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
Flat washer (4 each)
9. Cap screw (4 each)
10. Spacer
11. Flat washer (for pulley alignment)
12. Driven pulley
13. Flange nut
14. Roller brush
Note: Drive components for the rear roller brush are located on the opposite side
of the cutting unit from the cutting reel motor.
used when the brush drive is on the left side of the cutting unit.
Note: The Installation Instructions for the rear roller brush kit has detailed
information regarding assembly and adjustment. Use those Instructions along
with this Service Manual when servicing the rear roller brush.
1. Position machine on a clean and level surface, lower cutting units, stop
engine, engage parking brake and remove key from the ignition switch.
2. To remove roller brush from brush shaft:
A. Remove the non-drive brush bearing housing (item 1) from cutting unit.
B. Slide excluder seal from roller brush shaft.
Figure 364
15.
16.
17.
18.
19.
Page 9–57
Lock nut
J-bolt (2 each)
Grease fitting (2 each)
Grease seal (3 each)
Ball bearing (2 each)
Figure 364 shows components
Cutting Unit: Service and Repairs