Side-Shifting The Cutting Units - Toro Reelmaster 3100-D Operator's Manual

Cutting Grass with the Machine (continued)
6. Raise the cutting units off the ground using the cutting-unit-shift lever.
7. Once you reach the edge of the mowing area to start mowing, lower the cutting units
using the cutting-unit-shift lever.
Note:
area.
8. Complete the mowing pass.
9. When nearing the opposite edge of the fairway (prior to reaching the edge of the
mowing area), pull back the cutting-unit shift lever only long enough to raise the cutting
units, and release the lever.
Do not hold the cutting-unit shift lever back while turning.
10. Perform a tear-shaped turn to quickly line up for your next pass.

Side-Shifting the Cutting Units

Model 03171
1. Use the cutting-unit-shift lever to raise the
cutting units.
2. Move the cutting-unit-shift lever
to move the cutting units left or right.
3. Use the cutting-unit-shift lever to lower the
cutting units to the ground.
Operation: During Operation
Practice to ensure the cutting units do not lower early or mow an unintended
IMPORTANT
left or right
G402857
Page 5–6 3466-297 A