Servicing The Roller - Toro Reelmaster 5410 Series Service Manual

Servicing the Roller

Disassembling the Roller
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
g195108
1. Roller tube
2. Roller shaft
3. Inner seal
4. Bearing
1. Remove the bearing locknut from each end of the roller shaft.
2. Loosely secure the roller assembly in a bench vise and lightly tap one end of
the roller shaft until the outer seals and bearing are removed from opposite
end of the roller tube. Remove the second set of outer seals and bearing
from the roller tube by tapping on opposite end of the shaft. Remove the
shaft from the roller tube.
3. Carefully remove the inner seal from both ends of the roller tube, ensure that
you do not damage the tube surfaces.
4. Discard the seals and bearings that were removed.
5. Clean the roller shaft and all surfaces on the inside of the roller tube. Inspect
components for wear or damage. Also, carefully inspect the seating surface
and threads of the bearing locknuts. Replace all the components that were
damaged.
Figure 351
5. Outer seal
6. Bearing lock nut
7. Grease fitting
Page 9–47 Cutting Unit: Service and Repairs