Servicing The Lift Control Manifold - Toro Reelmaster 5410 Series Service Manual

Servicing the Lift Control Manifold

g216667
1. Lift control manifold
2. Check valve (4 each)
3. Solenoid valve (SV3)
4. Solenoid coil
Hydraulic System: Service and Repairs
5. Solenoid coil spacer
6. Nut
7. Solenoid valve (SV2)
8. Solenoid coil
Note: The ports on the lift control manifold are marked for easy identification
of the components. Example: P is the gear pump (P4) connection port and
SV2 is the location for solenoid valve SV2; refer to the Hydraulic Schematic in
Appendix A (page A–1)
valves at each manifold port.
For the control manifold service procedures; refer to
Cartridge Valve (page 6–200). Refer to
torque. Refer to Figure 170
Note: Solenoid valves SV1 and SV2 on the lift control manifold use a coil spacer
between the solenoid coil and nut.
Figure 169
9. Nut
10. Solenoid relief valve
(SVRV)
11. Solenoid valve (SV1)
12. Relief valve (R7)
to identify the function of the hydraulic lines and cartridge
Figure 169
for hydraulic fitting installation torque values.
Page 6–198
13. O-ring
14. Pilot piston (4 each)
15. O-ring
16. Hex plug (4 each)
Servicing a Control Manifold
for cartridge valve installation
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C