Control Arm - Toro Reelmaster 5410 Series Service Manual

Control Arm

g185923
1. Arm rest
2. Locknut
3. Engine speed switch
4. Reel engage switch
5. InfoCenter display
6. Control arm
7. Key switch
8. TEC (Toro Electronic Controller)
9. Fuse block
10. Joystick assembly
11. Screw
Disassembling the Control Arm
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
12. Right control arm cover
13. Swell latch (2 each)
14. Access cover
15. Washer-head screw
(10 each)
16. Foam seal
17. Platform wire harness
18. Flange nut (3 each)
19. Spring
20. Flat washer (2 each)
21. Clevis pin
22. Flange-head screw (2 each)
1. Park the machine on a level surface, lower the cutting units, shut off the
engine, set the parking brake, and remove the key from the key switch.
2. Disconnect the negative battery cable from the battery; refer to
Battery (page 7–125).
Figure 304
23.
24.
25.
26.
27.
28.
29.
30.
31.
32.
33.
Page 8–23
Retainer bracket
Clevis pin
Bolt
Latch
Cotter pin
Spacer
Flat washer
Cotter pin
Nylon bushing (2 each)
Left control arm cover
Headlight switch
Servicing the
Chassis: Service and Repairs