Gear Pump (P4) Flow Test (Using Tester With Flow Meter And Pressure Gauge) (5410/5410-G/5410-D/5510/5510-G/5510-D/5610) - Toro Reelmaster 5410 Series Service Manual

Gear Pump (P4) Flow Test (Using Tester with Flow Meter and
Pressure Gauge) (5410/5410-G/5410-D/5510/5510-G/5510-D/5610)
g230028
Test Procedure
Reelmaster ® 5410/5510/5610 Series
15216SL Rev C
The gear pump (P4) flow test should be performed to ensure that the cutting unit
lift circuit has adequate hydraulic flow.
1. Park machine on a level surface with the cutting units lowered and reel
engage switch O
FF
brake.
2. Read all Warning, Cautions, and precautions listed at the beginning of this
section.
Figure 103
. Ensure that the engine is shut off. Apply the parking
Page 6–89 Hydraulic System: Testing the Hydraulic System