Adjusting The Control-Arm Position; Installing The Cutting Units - Toro Reelmaster 5610-D Operator's Manual

2
Adjusting the Control-Arm
Position
No Parts Required
Procedure
You can adjust the control-arm position for your
comfort.
1. Loosen the 2 bolts securing the control arm to
the retaining bracket
1. Control arm
2. Retaining brackets
2. Rotate the control arm to the desired position
and tighten the 2 bolts.
(Figure 3).
Figure 3
3. Bolt
3

Installing the Cutting Units

Parts needed for this procedure:
1 Right front hose guide
1 Left front hose guide
Procedure
1. Remove the reel motors from the shipping
brackets.
Note:
Discard the shipping brackets.
2. Remove the cutting units from the cartons.
3. Assemble and adjust the cutting units as
described in the cutting unit Operator's Manual.
4. Make sure that the counter weight
installed to the proper end of the cutting unit as
described in the cutting unit Operator's Manual.
g004152
1. Counter weight
5. Mount the turf-compensation spring to the same
side of the cutting unit as the reel-drive motor.
Reposition the turf-compensation spring as
follows:
Note:
All cutting units are shipped with the
turf-compensation spring mounted to the right
side of the cutting unit.
10
(Figure
Figure 4
4) is
g003320