4 Replacement Procedures
8. Pull the FL assembly out of its groove on the mold frame.
Mold frame
Installing the TFT FL (Model 15.0 Samsung)
To install the model 15.0 TFT FL (Manufacturer: Samsung), follow the steps below and
refer to Figures 4-132 to 4-139.
1. Seat the FL in its groove on the mold frame.
2. Lay the back cover on the mold frame and secure it with two screws.
3. Lay six sheets on the back light assembly and secure them with two clips, one screw
and one strip of sheet tape.
4. Seat the panel assembly on the back light assembly.
5. Seat the top chassis and secure it with eight hooks.
6. Secure the chassis with five screws and wire tape.
7. Secure the PCB with two screws.
8. Apply the PCB cover and aluminum tape to the module.
4-166
Lamp assembly
Figure 4-139 Removing the FL assembly
Satellite 1400/2400 Series Maintenance Manual (960-364/365)
4.35 TFT FL (Model 15.0 Samsung)