Toshiba Satellite 1400 Series Maintenance Manual page 327

4.30 TFT FL (Model 14.1 Sharp)
10. Apply a new protective cover-S aligning the holes on it with the pins on the LCD
module. Then fold it down along the side of the top frame.
11. Apply a new protective cover-G aligning the holes on it with the pins on the LCD
module. Then fold it down along the side of the top frame.
12. Apply new aluminum tape aligning its length with a line on the lamp cover on the
back of the LCD module and align one end with the edge of the lamp cover.
13. Secure the wire with tape. Align the length of the tape with a line on the lamp cover
on the back of the LCD module and align one end with the edge of the frame so that
the tape covers a screw.
14. Apply tape aligning one of its corners with a corner of the rectangular hole on the
back of the LCD module.
Protective cover-G
Satellite 1400/2400 Series Maintenance Manual (960-364/365)
Pins
Figure 4-93 Applying the covers and tapes
4 Replacement Procedures
Aluminum tape
Tape to secure the wire
Protective cover-S
4-119