Installing The Hdd Connector Board - Toshiba Satellite 1400 Series Maintenance Manual

4 Replacement Procedures

Installing the HDD Connector Board

To install the HDD connector board, follow the steps below and refer to the figure below.
1. Seat the HDD connector board and carefully connect it to PJ2000 on the system
board.
2. Secure the HDD connector board with two M2×5 thin silver flat-head screws.
CAUTION: Be careful not to damage or pinch the FDD SUMI card when you seat the
HDD connector board. Make sure the wireless LAN switch is in the correct position.
PJ2000
4-50
PJ7001
4.13 HDD Connector Board
Satellite1400/2400 Maintenance Manual (960-364/365)
M2×5 thin silver flat-head screws
HDD connector board
Wireless LAN Switch